Warmlyyours Environ Flex Roll System For laminate/floating woo Manuale Utente Scaricare il pdf (Pagina 8)

Installing The Thermostat

If you are using a thermostat with a oor sensor, place the sensor under the Environ™ Flex Rolls, centered between two heat wires, at least 6” (150 mm) into the

heated area.

Make a small divot in the underlayment in this spot and secure the sensor head in the divot with tape. Run the sensor cable in a channel cut into the underlayment

from the heater and back to the thermostat. The “heater wires” within the roll are identied as raised parallel lines. The sensor wire should not cross over the foil heater

wires, and is better placed in a channel cut into the underlayment, under the roll.

HOT

THERMOSTAT SENSOR

(LOW VOLTAGE)

FROM POWER SOURCE 120V & 240V

SENSOR

Front

PB112C-GA

ENSURE THE SYSTEM IS GROUNDED

HOT (240V) or

NEUTRAL (120V)

HOUSE GROUND

Red (240) or

Yellow (120) Wires

Red

Black

Red

Copper

Ground

4x4 Box

Black

Black Lead

THERMOSTAT

Load

L2 (N)

L1 (L)

RED

BLACK

SENSOR

GROUND

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Installation Manual for your 1
CONTENTS 2
Environ™ Flex Roll System 3
Construction 3
Important Information 4
Introduction 4
Controlling Your System 5
OHM Testing 6
5/8” (15mm) 7
Installing The Thermostat 8
Installation of Environ™ 9
Flex Roll System 9
BEFORE YOU START 11
INSTALLING THE THERMOSTAT 12
INSTALLING THE PANELS 12
20004-B 6/2013 14

Commenti su questo manuale

Nessun commento

Warmlyyours Environ Flex Roll System For laminate/floating woo Manuale Utente Pagina 8

Commenti su questo manuale

Prodotti e manuali riguardandi Per casa Warmlyyours Environ Flex Roll System For laminate/floating woo